Art and music projects
IntermediateArt and music3D print16-step drum machine with an AI beat helper
A standalone drum machine: a lit 4x4 NeoTrellis pad grid programs 16-step patterns, a Teensy 4.1 plays drum samples from its SD card through the PJRC audio adaptor, and three knobs set tempo, swing and volume. An AI helper turns "boom-bap at 90 BPM" into patterns you load.
$75-125 · 8-12 hours (plus ~9 h printing)
IntermediateArt and music3D printAI photo booth with style filters
A Raspberry Pi camera in a simple booth or stand that takes a picture, applies a style or portrait effect on a computer you control, and shows the result on a screen. Guests should see that the stylized image is an illustration, not a candid snapshot.
$180-290 · 8-14 hours, plus about 12 hours if you print a stand and hood
IntermediateArt and music3D printAI-generated art pen plotter
A small belt-driven pen plotter that draws line art on paper. You turn an image or an AI line drawing into paths, then official GRBL moves the motors while you watch the pen work.
$100-160 · 10-16 hours, plus about 16 hours of printing
BeginnerArt and music3D printGenerative LED wall art with WLED
A framed LED matrix or strip running official WLED on an ESP32, with patterns that can react to sound or to a simple incoming effect. A bright, low-voltage art piece for a wall you already control.
$45-75 · 4-8 hours, plus about 8 hours of printing for a frame and diffuser
BeginnerArt and music3D printInfinity mirror with generative WLED patterns
A 12-inch square frame with a mirror at the back, a two-way mirror at the front and a WS2812B LED strip between them makes a tunnel of light that seems to go on forever. An ESP32 running WLED gives you over a hundred effects, schedules and phone control.
$80-100 · 4-6 hours (plus ~20 h printing)
IntermediateArt and music3D printKinetic sand table that draws patterns with a magnet
A desktop kinetic sand table based on the free Mini Dune Weaver: a hidden magnet under a printed tray drags a steel ball through fine sand to draw spirals and mandalas. Two 28BYJ-48 steppers and an ESP32 run the official Mini firmware; you control it from a web browser.
$75-120 · 4-8 hours (plus ~9 h printing)
BeginnerArt and music3D printLaser-cut AI pattern lamp
A lamp whose shade is an AI-generated pattern, cut in plywood or acrylic on a laser you already can use, sitting on a 3D-printed or ready-made base with a listed lamp kit or a low-voltage LED.
$30-55 · 3-6 hours, plus about 4 hours if you print a base, plus laser time at a shop
IntermediateArt and music3D printMIDI controller that jams with an AI model
A small USB MIDI pad or keyboard you build or enclose, talking to a computer running a music model or official Magenta tools, so you can play a phrase and hear a continuation.
$25-45 · 6-10 hours, plus about 6 hours of printing for a case
BeginnerArt and music3D printTouchless ToF theremin with an AI-written backing band
Wave your hands over two VL53L1X time-of-flight sensors: one hand sets the pitch, the other the volume. A Raspberry Pi Pico sends USB MIDI to your computer's synth, and a small AI-written Python script listens and plays chords and bass in the same key.
$35-45 · 3-5 hours (plus ~4 h printing)
Every project lists the parts, filament, AI agents and safety notes we checked on the date shown. Pictures are illustrations, not photos of a finished build. Spot a mistake? Tell us on the boards.